AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Shark duo clean vacuum cleaners1/14/2024 Rinse the filter well in clear water and allow it to dry fully.ĭo not return the filter(s) to the vacuum at this point. Firmly pull the door off to reveal the HEPA filter and pull out the filter. This is located on the lower front of the machine behind the filter grill (door). Most Shark vacuum models have an additional filter-a HEPA filter. I’m not too fond of dirty felt, so I carefully hand wash and have done so many times with no problem. NOTE: The manufacturer does not recommend washing the felt filter. As long as they are not torn, broken, or otherwise disintegrated, they’ll be just fine, even if they remain stained. Once cleaned and rinsed well, the filter(s) may or may not return to their new white appearance. It takes a good amount of squeezy and scrubbing of the foam filter to get it clean. Rinse the foam and felt filters in cool, clear water (manufacturer recommends no soap), being especially careful not to damage them. Shark vacuums have an excellent filter system consisting of one or two (depending on the model) thick foam filters plus one made of felt and a HEPA filter. MORE: So Disgusting I’m Embarrassed to Tell.Once rinsed, dry it thoroughly with a good microfiber cloth. Using a long-handled brush or a rag, get inside that canister and scrub it clean. Open both ends of the dust canister and put it right into that warm bath. Now take the canister to a sink of warm soapy water. Open both ends of the dirt canister over a trash can and dump out whatever is in there. Step 3: Empty and clean the dirt canister Make sure you are working in a well-lit area and using a flashlight to help search for blockages. Can’t reach it? A wooden skewer works well to fish out or release any weird accumulation. Remove all obstructions using your hand or a damp microfiber cloth. You may find other things like a Lego brick or maybe even a sock! You’re likely to see fuzz, hairballs, and clinging dust. Step 2: Check for and clear obstructionsĬheck every opening. Take note of the placement of the filters so that you can replace them in the same proper order. Remove the dust canister, the foam/felt filters, the HEPA filter and its cover, and the handle hose. We’re not talking about removing screws or detaching wires. Make sure the vacuum is disconnected from power, then take it apart. If you get stuck, ask in the comment area below, or refer to your owner’s manual. However, my experience is that all Shark vacuums have the same basic parts and operate similarly. In the more than 12 years I’ve been using Shark vacuums, the company has come out with a crazy number of models. If it does, consider that a clear sign this vacuum is overdue for a good cleaning.
0 Comments
Read More
Leave a Reply. |